Filter
Top Products
The procedure to panel-mount the Profile Controller is shown in Figure 1-3.
CAUTION: Do not remove the panel gasket, as this may result in
inadequate clamping of the instrument in the panel.
NOTE: When installing several instruments side-by-side in one
cut-out, use the ratchets on the top/bottom faces.
Once the Profile Controller is installed in its mounting panel, it may be
subsequently removed from its housing, if necessary, as described in Subsection
2.1.
1.3
CONNECTIONS AND WIRING
The rear terminal connections are illustrated in Figure 1-4.
This instrument is designed for installation in an enclosure
which provides adequate protection against electric shock.
All pertinent local regulations should be rigidly observed.
Consideration should be given to prevention of access to the
rear terminals by unauthorised personnel.
1-2 Volume I S077-1
Gaske t
Profile
Controlle r
Ho using
Mounting panel
Ratc hets
Hold Profile Controlle r firm ly in p osition
(apply pressure to bezel only)
Slid e m ounting c la m p ove
r
Profile Controlle r housing towa rd s
rear face of mounting panel
until tongues engage in ratchets
a nd Profile Controlle r is c la m p e d
firm ly in p osition.
Figure 1-3 Panel-Mounting the Profile Controller