Filter
Top Products
2 CONTROLLER SET-UP MODE
In this mode, the parameters which define the operation of the controller are
defined. Controller Set-Up Mode can be entered (whether or not there is a
program currently running) as follows:
NOTES:
1. If the Controller Set-Up Mode lock code has been set to 0, pressing the
Scroll key in Step 2 will give direct access to Controller Set-Up Mode; no
entry of lock code is required.
2. If the upper display initially shows all decimal
points illuminated (see right), one or more
configuration parameters have been altered and,
as a consequence, all Controller Set Up Mode
parameters have been automatically set to their
default values/settings. To clear this display, simply alter the value/setting
of any Controller Set Up Mode parameter.
Upon entry into Controller Set-Up Mode, the first in a sequence of controller
parameters will be displayed. The operator may then step through the parameter
sequence using the Scroll key, adjusting the setting/value of each displayed
parameter using the Up/Down keys. The parameter sequence is as follows:
O077-2 Volume II 2-1
Press
simultaneously
Press
Press
To display
Rolling display -
changes every 2 seconds
when display shows:
to display:
Set upper display to
Controller Define lock code
then:
NOTE: Default
(factory-set) lock
code is 10.