Filter
Top Products
3.2.2 Defining Segments - Rate Mode
3-3 Volume II O077-3
To make a
Ramp segment
To make a
Soak segment
To make an
End segment
Set desired
ramp rate value
Press
simultaneously
or set ramp rate
to zero
Press
simultaneously
or set ramp rate
to zero
Press
Set desired
final setpoint
value
Set desired
segment time
Move to next segment
To Program
Options (see
Subsection 3.2.4)
NOTE: Ramp rate is in units/hour if
Ramp rate is in units/minute if
=
=
See
Subsection
3.2.4
In this mode, the controller is progammed
to ramp to setpoint at a specified number
of units per time base (ie 50 deg/hour).