Filter
Top Products
NOTE: When a program is aborted, the instrument returns to the Controller
Setpoint value. If a program is successfully completed, the Controller
Setpoint is automatically set to the final setpoint value of the program. If it
is desired to restore the initial Controller Setpoint value after the program
is completed, this value should be used as the program Final Setpoint
value.
1.6 DISPLAY SEQUENCE - PROGRAM RUNNING
O077-1 Volume II 1-3
Process Variable
value
Setpoint
value
Read only
Active program setpoint value
Final setpoint value for current segment
Time remaining in current segment
Cycles remaining for current program;
for infinite cycling =
Current selected control mode:
Event output/Alarm status:
Number of currently-running/held program (1 - 4)
= Automatic
= Manual
Event output: E = active, blank = inactive
Alarm 1: 1 = active, blank = inactive
Alarm 2: 2 = active, blank = inactive
Omitted if No. Of Cycles = 1 (i.e. No cycling)
Omitted if Manual Control is disabled (see Section 2)
Omitted if all
three are
inactive
NOTE: All displays are
Read Only whilst
program is running/held.