Filter
Top Products
1.2 STARTING A PROGRAM
To start a program running:
1.3 PUTTING A PROGRAM IN HOLD
A program can be put in Hold (i.e. frozen) at any time whilst it is running. The
program setpoint will stay at its value at the instant the program entered Hold
until the program is released (see Subsection 1.4) or aborted (see Subsection 1.5).
To put a program in hold, momentarily press the
RUN key. The RUN indicator
will flash whilst the program is in hold.
1.4 RELEASING A PROGRAM FROM HOLD
To release a program currently in Hold, momentarily press the RUN key. The
RUN indicator will then go ON continuously.
1.5 ABORTING A PROGRAM
To abort the current-running (or held) program, hold down the RUN key for 5
seconds. The program will be aborted, the
RUN indicator will go OFF and the
normal Controller functions will be resumed.
1-2 Volume II O077-1
Select required
Program Number (1 - 4)
Select required
delay time
(in hours.minutes)
for delayed start -
intherange0to
99.59. Default = 1:00
PROGRAM
STARTS
This display appears
only if the Delayed Start
facility is enabled.
( indicator
comes ON
)
RUN