Filter
Top Products
* Appears only if a thermocouple input is selected (see Hardware Definition Code).
3-8 Volume I S077-3
Parameter Identifier Description
D & Ñ LEDs
Usage
(on Front Panel)
Ramp direction:
D = positive ramp
Ñ = negative ramp
both = soak
Output state:
D = Output 1 ON
Ñ = Output 2 ON
Guaranteed Soak
Enable/Disable
(see Volume II,
Subsection 3.2.5)
Enabled
Disabled
Manual
Delayed Start
Enable/Disable
Enabled
Disabled
Power Loss
Recovery
Cold Start (program re-started from
beginning)
Warm Start (program resumed from
point at which power failed)
Start On Start program with setpoint at
current process variable value
Start program with setpoint at
Controller Setpoint value
Communications
Protocol
MODBUS with odd parity
MODBUS with even parity
MODBUS with no parity
Communications
Baud Rate
Selectable: 1200, 2400, 4800, 9600 Baud
Communications
Address
Unique address assigned to the Profile Controller;
in the range 1 - 255.
Cold Junction
Compensation
Enable/Disable*
Enabled (default)
Disabled