Filter
Top Products
B. Word Parameters
4-8 Volume II O077-4
No. Parameter Notes
Controller Parameters
1 Process Variable Read only
2 Setpoint Current setpoint, if ramping
3 Output Power Read only, unless in Manual Control
4 Arithmetic Deviation Read only
5 Proportional Band 2
6 Proportional Band 1
7 Controller Status
8 Reset
9 Rate
10 Output 1 Cycle Time
11 Scale Range Low Read only if non-linear input
12 Scale Range High Read only if non-linear input
13 Alarm 1 value
14 Alarm 2 value
15 Manual Reset
16 Overlap/Deadband
17 ON/OFF Differential
18 Decimal Point Position Read only if non-linear input
19 Output 2 Cycle Time
20 Output 1 Power Limit
21 Setpoint Lock 0 = Off, 1 = On
22 Reserved
23 Filter Time Constant
24 Process Variable Offset
25 Recorder Output Max.
26 Recorder Output Min.
27 Alarm 1 Hysteresis
28 Alarm 2 Hysteresis
Program Parameters
29 Segment Mode 0 = Rate, 1 = Time
30 Profiler Status Read only - see Subsection 4.5.
31 Current Program Number Read only
32 Current Segment Number Read only in current running/held program
33 Segment Time Remaining Read only