Filter
Top Products
1 INSTALLATION
1.1
UNPACKING PROCEDURE
1. Remove the Profile Controller from its packing. The Controller is
supplied with a panel gasket and push-fit fixing strap. Retain the
packing for future use, should it be necessary to transport the Profile
Controller to a different site or to return it to the supplier for
repair/testing.
2. Examine the delivered items for damage or deficiencies. If any is
found, notify the carrier immediately.
1.2
PANEL-MOUNTING THE CONTROLLER
The panel on which the Profile Controller is to
be mounted must be rigid and may be up to
6.0mm (0.25 inches) thick. The cut-out required
for a single Profile Controller is as shown in
Figure 1-1.
Several instruments may be installed in a single
cut-out, side-by-side. For n Profile Controllers
mounted side-by-side, the width of the cut-out
would be:
(48n - 4) millimetres or (3.78n - 0.16) inches.
The Profile Controller is 110mm deep (measured from the rear face of the front
panel). The front panel is 48mm high and 48mm wide. When panel-mounted, the
front panel projects 10mm from the mounting panel. The main dimensions of the
Profile Controller are shown in Figure 1-2.
S077-1 Volume I 1-1
45m m +0.5 -0.0
45m m +0.5 -0.0
Figure 1-1
48m m
48m m
110m m
Figure 1-2 Main Dimensions