Filter
Top Products
3 CONFIGURATION MODE
3.1 ENTRY INTO CONFIGURATION MODE
NOTE: Changes to the value/setting of certain Configuration Mode
parameters (e.g. input range, output use and type) will cause the Set
Up Mode parameters to be automatically set to their default values
the next time Set Up Mode is entered (see also Volume II, beginning
of Section 2).
3.2 HARDWARE DEFINITION CODE
This parameter is a special facility in Configuration Mode, which is used to
represent the hardware fitted (input type, Output 1 type, Output 2 type and
Output 3 type); this must be compatible with the hardware actually fitted. For
access to, and adjustment of, the Hardware Definition Code, see Figure 3-2 and
Table 3-1.
S077-3 Volume I 3-1
Powe r-up the Profile Controlle r.
In Configurat ion Mode:
Within 30 secs. as 1st
key action after power-up.
To sel ect
parameter
To change value
(upper display flashes)
To confir m new
value (upper
display is static)
Profile Controller is in
Configuration Mode and
displays current input code
HOLD DOWN
SIM U LTA N EO U SLY
To di spl ay
Va l u e
Identifier
For five seconds
Figure 3-1 Entry into Configuration Mode