Filter
Top Products
6
14.7.8 STORING HARDWARE
CONFIGURATION
To enable the system to check that all
modules are communicating with the
processor, the hardware configuration has to
be stored in the memory of the system. This
must be done whenever a change is made in
the hardware configuration and after the
memory is cleared.
This is the only possible program option
when entering the programming mode after
clearing the memory.
8.1 Main menu selection
Select from the main menu by means of the
left/right arrow keys:
STORE HARDWARE
8.2 Busy storing
After pressing ENTER, the display will
show ‘busy storing’ for a short moment.
Programming will automatically continue
with the first step of the Installer
Programming.
14.7.9 SELECTING AMPLIFIER
CONFIGURATION
The SM30 system is intended for use with 2
separate amplifier channels: a music channel
and a call channel. It is possible however, to
use only 1 amplifier channel for both calls
and music.
In order for the system to function correctly,
SM30 must know which option is chosen.
See chapter 5, ‘Connecting Amplifiers’ for
consequences of using 1 channel.
9.1 Main menu selection
Select from the main menu by means of the
left/right arrow keys: AMPLIFIER
CONFIG.
9.2 Configuration display
The current setting will be displayed. If the
memory has been cleared, the default option
‘SEPARATE AMPS’ is displayed.
9.3 Altering selection
The option can be altered using the
up/down arrow keys.
Amplifier Configuration
SELECT PROGRAM :
AMPLIFIER CONFIG
AMPLIFIER CONFIG
SEPARATE AMPL'S
AMPLIFIER CONFIG
SINGLE AMPLIFIERS
1
2
9
3
Store Hardware
STORE HARDWARE
SELECT PROGRAM :
BUSY STORING ...
SELECT PROGRAM :
8
1
1
2
GB/SM 30 user manual 5/26/98 10:18 AM Page 6