Filter
Top Products
41
2.7 Programming Control Relays
This display will be skipped if the Control
Relay Module is not present in the system.
The current setting of Control relays 1-6 is
shown. Shifting the cursor to the right,
further than the last position, will display
the current setting of relays 7-12. Selecting a
zone can be done with the ‘|’ key.
Deselecting a zone can be done with the ‘O’
key. Relay 1 (marked ‘X’) is reserved for the
activation of internal system error indicators
and cannot be programmed for any other
function. Relay 2 (marked ‘X’) is reserved
for the activation of Call Station error
indicators and cannot be programmed for
any other function. Relay 3 is dedicated to
the ‘Delayed Power On’ function, but may
be used for other functions if Power On
Delay is not used. If it is used, the third
position will be marked with an ‘X’ in the
display.
Programming next microphone
When programming of the first microphone
is completed, pressing ENTER returns to
the next microphone number to be
programmed.
Microphones
SELECT PROGRAM :
MICROPHONES
SELECT ITEM :
MICROPHONE : X
MICROPHONE : X
MICROPHONE : X
PRIORITY : X
SIGNAL : XX
2
4
1
2
3
MICROPHONE : X
MICROPHONE : X
MICROPHONE : X
MESSAGE : X
000000 ZONE : 01
XX0000 REL : 03
7
6
5
GB/SM 30 user manual 5/26/98 10:18 AM Page 41