Filter
Top Products
Configuring via WIN-PAK
Adding a New NetAXS™ Panel
NetAXS™ Access Control Unit User’s Guide, Document 800-04410, Revision A 67
3.2.2 Configuring the Panel Manually
Use the WIN-PAK Panel Configuration screen to complete the NetAXS™ panel configuration
manually. All of the configuration screen options are supported for NetAXS™ panel configuration,
except where they are noted otherwise in this section.
Note: You cannot initialize the NetAXS™ panel from the WIN-PAK Control Map until you complete
the steps in this section.
If you are using the Device Map to add the NetAXS™ panel manually, add it as you would an
N-1000-IV-X panel.
1. Display the Basic tab of the WIN-PAK Panel Configuration screen. The Name, Description,
and Type fields contain the entries selected in the Quick Start Wizard:
Figure 3-2: WIN-PAK Panel Configuration Screen - Basic Tab
2. Enter the following selections for the remaining fields:
– Firmware version – 8.07 or later.
– Status – Active.
– Address – Select the appropriate panel number.