Filter
Top Products
Configuring via the Web Server
Configuring the System
NetAXS™ Access Control Unit User’s Guide, Document 800-04410, Revision A 31
2.4 Configuring the Doors
Each NetAXS™ panel supports four doors. For each door, you must configure the readers, inputs, and
outputs.
At Configuration > Doors in the task menu at the left margin of the NetAXS™ screen, click
1 to
display the Door Configuration screen for door 1. Follow the same procedures below for doors 2, 3,
and 4 for each panel.
2.4.1 Reader Tab
A reader is a device that reads cards and either grants or denies access at the door.
Click the
Reader tab:
Figure 2-11: Configuration > Doors > Reader > General Tab
The Reader tab enables you to:
• Define the time zone during which the reader will be disabled. When the reader is disabled,
neither exit nor entry by Card and PIN mode or Card or PIN mode is allowed. Also, free egress
is not allowed.
Note: Should a conflict arise among the time zones set in the Access Mode Time Zones box on
the Reader > General tab, priority is given to the time zone that is highest in the list of time
zones displayed on the tab. Therefore, the Disabled time zone has highest priority, and the Card
Only time zone has lowest priority.