Filter
Top Products
42
LCD DTL (Emphasizing outlines) ■
Emphasizing the outlines of the images you
see on the LCD makes it easier to focus.
Emphasizing the outlines does not affect the
images you record.
When this is set, the “LCD DTL ON” message
is displayed in the middle of the screen. (CAM
mode only)
Press the [USER] button again to cancel.
• This function is not canceled even when the
power is turned off.
• When the [USER] button is used to switch
between performing and canceling this
function, the [LCD DTL] setting in the
[DISPLAY SETUP] setup menu is also
switched.
LCD REVERSE (Reversing image display)
■
While the [USER] button is pressed, viewing
angles and video images can be verified by
reversing the images displayed on the LCD
monitor horizontally and vertically.
The recorded images are not affected when the
images are reversed on the screen.
• The normal display is shown when the [USER]
button is not pressed.
INDEX (Index function)
■
This function allows you to add an index at a
certain point of a clip during recording.
Press the [USER] button during recording or
shooting. “INDEX” is displayed on the screen
and an index signal is recorded at that point.
• To add an index during playback, select
[INDEX] → [YES] from the [OPERATION]
setup menu. (Pages 64, 91)
• If an index cannot be added, “INVALID” is
displayed.
• Added indexes can be deleted in PB mode.
(Page 64)
• Up to 100 indexes can be recorded for one
clip.
• When the number of indexes exceeds 100,
“INVALID” is displayed, and no further indexes
can be added even when the steps for adding
indexes are taken.
• When repeatedly adding indexes, leave a gap
of at least one second between adding one
index and the next. If indexes are added with
a gap of less than one second between them,
only the first operation will be valid.
SHOT MARK (Shot mark function)
■
The marks added to clip thumbnails are called
shot marks. In the thumbnail screen, only clips
with a shot mark can be selected for display or
playback.
Press the [USER] button during recording or
shooting. “MARK ON” is displayed on the LCD
monitor screen and a shot mark is set for the
thumbnail of the clip being recorded. Press the
button again to cancel.
You can also set or cancel shot marks in the
thumbnail screen of PB mode. However, note
that you cannot set or cancel shot marks during
playback.
• If shot marks cannot be set or canceled,
“INVALID” is displayed.
LAST CLIP (Last clip delete function)
■
Deletes the last clip that was recorded or shot.
When the [USER] button is pressed during
recording or shooting standby, the “DELETE
LAST CLIP?” message is displayed on the LCD
monitor screen. Select [YES] to delete the last
clip that was recorded or shot.
If you do not want to delete the clip, select [NO].
• If one of the following operations is performed
after finishing recording or shooting, the last
clip cannot be deleted even if the [USER]
button is pressed.
• Mode is changed to PB mode
• Recording format is changed
• Portable recorder’s power is turned off and
back on again
• SD Memory Card is removed
Using the [USER] button (continued)