Filter
Top Products
Preparation
27
The tally lamp turns on during recording (red).
Also, the tally lamp flashes in the following
circumstances.
(flashes 4 times per second)
Recording error has occurred •
Battery has run out•
SD Memory Card is full •
System frequency has been changed•
(flashes once per second)
Remaining battery capacity is low •
Remaining memory of the SD Memory Card is low•
Setup menu has been initialized (Page 30) •
When the AG-HCK10G camera head
■
(optional) is connected
The tally lamp flashes in the following circumstances.
(flashes 4 times per second)
Cooling fan is not operating correctly•
Internal temperature of the camera is abnormally high•
Recording signal is corrupted•
Optical Image Stabilizer is not operating correctly•
Problem with the focus function•
Camera cable is disconnected•
AUDIO MON/ADV
REC/
PAUSE
REC/
PAUSE
Tally lamp
SD Memory Card access lamp
The SD Memory Card access lamp lights as
follows depending on the access condition of the
SD Memory Card in the portable recorder.
REC mode, PB mode
■
Illuminated orange: Reading/writing possible
Flashing orange (fast): Verifying card/inspecting
card for possible defects
Flashing orange (slow): Accessing card
(recording, playing back
or loading)
Off: No card inserted/unformatted or incompatible
card inserted
PC mode
■
Flashing orange (slow): Accessing card
Off: A status other than accessing
SD Memory Card access lamp
Do not perform any of the following operations •
while the SD Memory Card access lamp is
flashing.
Performing these operations may damage the
SD Memory Card or its contents, or cause the
portable recorder to fail to operate correctly.
Removing the SD Memory Card ·
Switching off the power ·
Removing the battery ·
Connecting or disconnecting the USB ·
connection cable
Shaking or striking the recorder ·
Tally lamp