Filter
Top Products
TERMINAL SETUP
Connecting the Terminal Power Pack
28 V
X
670 INSTALLATION GUIDE
Connecting the
Terminal Power
Pack
When you have finished installing the smart battery, you are ready to connect the
V
x
670 terminal to the provided power source for initial charging.
The V
x
670 unit comes with a universal input power pack capable of operating
from voltages of 100VAC to 240VAC.
To Connect the
Terminal Power Pack
1 Insert the round barrel connector into the power port in the connector, as
shown in Figure 19.
Figure 19 V
x
670 Power Pack Connection
2 Insert the AC power cord into the power pack.
3 Plug the AC power cord into a wall outlet or powered surge protector.
When the terminal has power, the terminal lights are activated and the LED
indicator remains lit.
CAUTION
Using an incorrectly rated power supply may damage the terminal or cause it not
to work as specified. Before troubleshooting, ensure that the power supply being
used to power the terminal matches the requirements specified on the bottom of
the terminal. (See Chapter 3, Specifications, for detailed power supply
specifications.) Obtain the appropriately rated power supply before continuing
with troubleshooting.
WARNING
Do not plug the power pack into an outdoor outlet or operate the terminal
outdoors.
During a transaction, disconnecting the power by removing the battery or
unplugging the terminal from a wall power while at very low battery charge may
cause transaction data files not yet stored in the terminal memory to be lost.
NOTE
To protect against possible damage caused by lightning strikes and electrical
surges, consider installing a power surge protector.