Filter
Top Products
TERMINAL SETUP
Battery Behavior (No Power Cord)
26 V
X
670 INSTALLATION GUIDE
• activates when the battery is left in an unused terminal for extended
periods.
Battery Behavior
(No Power Cord)
If you connect the V
x
670 to a non-battery power source, the terminal shifts to
corded power mode and starts up automatically, regardless of the battery charge
state.
Manual Startup
Hold the green key down for about 4 seconds until the terminal displays the
startup screen.
When the terminal has power, the terminal lights are activated and the green LED
indicator remains lit.
NOTE
• Lithium-ion batteries are not affected by shallow charging. Furthermore, when
the terminal has no external power source or battery the coin cell battery
provides power to the security circuit.
• Uninstalling the battery and unplugging the terminal power pack reduce the
life of the coin cell battery, which does not recharge and must be replaced if
drained.
• Conserve battery power by turning the V
x
670 terminal off when not in use. If
the terminal is not to be used for an extended period of time, keep the Lithium-
ion battery inserted in the terminal, and power up the terminal periodically to
check the battery charge. Do not let the battery charge fall below 10% for
extended periods of time as this may permanently diminish the battery
capacity. Recharge the battery by attaching the power cord to the terminal and
plugging the power pack into a wall outlet.
NOTE
The 4-second power-up delay is for preventing terminal startup if the green key is
accidentally held down. The time required to hold the green key down to power up
the terminal is configurable (for more information, see the V
x
670 Reference
Manual – VPN 24004).
NOTE
If an application is loaded in the terminal, it starts after the initial VeriFone
copyright screen and usually displays a unique copyright screen. If no application
is loaded in the terminal,
DOWNLOAD NEEDED appears on screen after the initial
VeriFone copyright screen.