Filter
Top Products
TERMINAL SETUP
Installing/Replacing SIM Card (GSM/GPRS Models Only)
24 V
X
670 INSTALLATION GUIDE
6 Install an MSAM card by aligning the card and carefully sliding it within the
guides on the cover until it is fully inserted (see Figure 14). The MSAM card
holders are labeled MSAM1, MSAM2, and MSAM3.
Figure 14 Installing MSAM Card
7 Install the battery (see Figure 17).
Installing/
Replacing SIM
Card
(GSM/GPRS
Models Only)
The V
x
670 terminal supports the installation of a SIM (Subscriber Identity Module)
card. Use the following procedure to replace or install a SIM card.
1 Place the terminal upside down on a soft, clean surface to protect the lens
from scratches.
2 Remove the battery.
Figure 15 Removing the Smart Battery
3 After removing the battery, the SIM compartment is exposed. The SIM card
holder is labeled RADIO SIM.
NOTE
Before inserting the MSAM card, position it as shown in Figure 14, with the card’s
gold contacts facing the smart card reader end of the terminal. The cardholder
connector base has a set of contacts and a notch on one corner to ensure the
MSAM card is positioned correctly. The MSAM card has a notch on one corner to
ensure that it fits into the connector base in only one way. The MSAM
compartment door will not close properly if the MSAM cards are installed
incorrectly.