Filter
Top Products
TERMINAL SETUP
Using the Smart Battery
V
X
670 INSTALLATION GUIDE 25
4 Insert the SIM into the cardholder.
Figure 16 Inserting SIM Card
5 Install the battery (see Figure 17).
Using the Smart
Battery
The V
x
670 terminal uses an Li-ion smart battery (see Accessories and
Documentation for ordering information). The internal logic of the smart battery
prevents both overcharging and undercharging (a fault condition in which the
battery level goes well below the minimum acceptable charge and the battery
becomes unusable).
Smart Battery
Features
The following are features of the smart battery:
• Two Li-ion cells
• A fuel gauge module that:
• monitors state of charge (voltage and percentage of capacity),
• communicates with the terminal (charge parameters and status),
• determines full charge capacity (on charge cycle and uninterrupted
discharge cycle), and
• automatically shuts down when cell voltage is extremely low.
• A safety circuit that:
• prevents cell damage from overcharge, over-discharge, or overheating,
and
NOTE
There is only one SIM slot, but there are multiple SAM slots. Make sure you insert
the SIM card into the SIM slot, as shown in Figure 16.
NOTE
The V
x
670 terminal will operate on battery power or on power pack power. The
smart battery charger in the terminal will be active whenever the power pack is
connected.