Filter
Top Products
[Table of Contents] [Previous Page] [Next Page]
16. TROUBLESHOOTING
In case a problem occurs, first check wiring connector connections.
PROBLEMS CAUSE COUNTERMEASURES
When the main power is
not on, the machine is not
activated.
The
p
ower is not ON. Firml
y
insert the
p
lu
g
into the outlet.
Incorrect power source/voltage.
Make sure that the power supply/voltage
are correct.
AC Unit fuse blown off due to
instantaneous overcurrent.
First remove the cause of overcurrent,
then re
p
lace the fuse
(
see Sec. 6
)
.
514-5036-15000
FUSE 6.4 ØX 30
15000mA 125V
AC100~120V
AREA
514-5037-8000
FUSE 6.4 ØX 30
8000rnA 250V
AC220~240V
AREA
PTV screen is blackened
and the fluorescent lamp
does not light up.
Power supply unit fuse blown
off due to instantaneous
overcurrent.
First remove the cause of overcurrent,
then re
p
lace the fuse.
514-5036-10000
FUSE 6.4 ØX 30 10000mA 125V
PTV screen is all blue.
Defective connections in
b
etween each board.
Make sure of correct connections in
b
etween each board.
The color of image on
PTV screen is incorrect.
Connector connections are
defective.
Check to see if connector connections of
RGB and SYNC are correct.
Incorrect monitor adjustment.
Make appropriate adjustments (see Sec.
13
)
.
PTV screen has a color
deviation.
Affected by the periphery, such
as other machines, location
building's steel frames, etc.
Make convergence adjustments (see Sec.
13
)
.
Change installation direction/position.
Move the other machines which cause the
p
roblem.
Sound is not emitted. Sound volume adjustment is not
correct.
Adjust the SWITCH UNIT's sound
ad
j
ustment volume
(
control
)
(
see Sec. 8
)
.
Malfunctioning of sound BD
and memor
y
.
Perform SOUND TEST (see Sec. 8).
Control panel and pedal
not operable satisfactorily.
V. R. position deviated, or V. R
malfunctionin
g
.
Adjust or replace the V. R. (see Sec. 9 &
10
)
.
ADJUST GEAR's engagement is
not correct.
Adjust the engagement of ADJUST
GEAR
(
see Sec. 9 & 10
)
.
SHIFT LEVER doesn't
operate satisfactorily.
Switch position deviated, or
switch malfunctioning.
Adjust or replace the
Switch (see Sec. 11).
509-5566
SW MICRO
TYPE
Steering Wheel reaction
First turn the
p
ower off and then turn it
Pa
g
e 1 of 2Troubleshootin
g
7/12/2005htt
p
://www.sauservice.com/manuals/Da
y
tona%20Folder/DDhtml/DD45.html