Filter
Top Products
[Table of Contents] [Previous Page] [Next Page]
10. ACCELERATOR & BRAKE
In the test mode, if the ACCEL. & BRAKE V.R. value is not within the allowable range, an adjustment
of V.R. installation position, or a replacement of V.R. is needed. Also, grease the MECHA's shafts and
sliding portions once every 3 months.
When performing the above work, take off the 4 truss screws and remove the front cabi's front lid.
10-1 ADJUSTMENT AND REPLACEMENT OF VOLUME
FIG. 10.1
The ACCEL. & BRAKE MECHA can be seen by removing the front lid. The ACCEL. V.R. is on the
left- hand side and the BRAKE V.R. is on the right-hand side of the MECHA. Check the V.R. value in
the test mode. The appropriate value of each V.R. is as follows:
Method of V. R. replacement
To replace the V.R., after taking off the connector from the V.R. to be replaced, take out the 2 screws
which secure the VR BRACKET, and remove the V.R. together with the bracket and gear. After the
re
p
lacement, check the V.R. value variations in the test mode.
When released: When ste
pp
ed on:
ACCEL.: Under 2 DH <---> Over D3H
BRAKE: Under 2 DH <---> Over D3H
Pa
g
e 1 of 2Volume
7/12/2005htt
p
://www.sauservice.com/manuals/Da
y
tona%20Folder/DDhtml/DD35.html