Filter
Top Products
[Table of Contents] [Previous Page] [Next Page]
METHOD OF V.R. ADJUSTMENT
1. Loosen the 2 screws which secure the V.R. BRACKET, move the V.R. BRACKET and disengage
the gears.
2. Cause the V.R. value to match with the value obtained when the pedal is released.
3. Cause the gears to be engaged and secure the V.R. BRACKET. At this time, be sure to obtain an
appropriate backlash.
4. Step on the pedal and check the V.R. value variation.
10-2 GREASING
Grease the gears and bearings once every 3 months as a standard.
11. 4 SPEED SHIFTER
In the test mode, if the shift lever input is found to be irregular, replace the switch or adjust the switch
installation position. Also, grease the MECHA's shafts or sliding portions once every 3 months as a
standard.
When performing the above work, remove the shift lever unit.
11-1 REMOVING THE SHIFTER
1. Take off the 4 tamperproof screws and remove the design plate.
2. Take out the 4 hexagon bolts and pull the shift lever unit upward. At this time, pay careful
attention so as not to cause damage to the wiring.
3. Disconnect the two connectors to allow the unit to be removed.
Pa
g
e 1 of 24 S
p
eed Shifter: Removin
g
7/12/2005htt
p
://www.sauservice.com/manuals/Da
y
tona%20Folder/DDhtml/DD36.html