Filter
Top Products
[Table of Contents] [Previous Page] [Next Page]
9. CONTROL PANEL (HANDLE MECHA)
In the TEST mode, if the steering wheel V. R. value variations are not within the allowable range, an
adjustment of the V. R. installation position or replacement of the V. R. are needed. Also, apply grease
to the steering wheel mechanism's shaft and sliding portions once every 3 months. When carrying out
the above work, take off the 4 truss screws and remove the front cabi's Front Lid Upper.
9-1 REPLACING AND ADJUSTING THE HANDLE's (STEERING WHEEL's) V.R.
FIG. 9.1
The upper side V. R. of the HANDLE MECHA is for the GAME BD., and the lower side one. for the
DRIVE BD. Check the value of the V. R. for the DRIVE BD. The appropriate value of each V. R. is as
follows:
Method of V. R. replacement
To replace the V. R., after taking off the connector from the V. R. to be replaced, take out the 2 screws
which secure the VR BRACKET, and remove the V. R. together with the bracket and gear. After the
re
p
lacement, check the V. R. value variations in the test mode.
When the steering wheel is
turned to or
p
ositioned at:
Left Centering position Right
V. R. for the GAME BD.: Under 2 DH --7DH~83H --> Over D3H
V. R. for the DRIVE BD.: Under 2 DH --7DH~83H --> Over D3H
Pa
g
e 1 of 2Handle's V.R.
7/12/2005htt
p
://www.sauservice.com/manuals/Da
y
tona%20Folder/DDhtml/DD33.html