Filter
Top Products
[Table of Contents] [Previous Page] [Next Page]
8-6 INPUT TEST
When INPUT TEST is selected, the monitor will show the following, allowing you to watch the status
of each switch and the value of each V.R. of the CONTROL PANEL.
On this screen, periodically check the status of each switch & V.R.
z
By pressing each switch, if the display on the right-hand side of the name of each switch changes
to ON from OFF, the SW and the wiring connections are satisfactory.
z
To check CHUTE 1 & CHUTE 2 coin switches, open the COIN CHUTE DOOR and insert a coin
(s) from the coin entry.
z
To return back to the MENU mode, simultaneously press VR1 & VR2, or press the TEST SW.
FIG. 8.6 INPUT TEST
An appropriate value of each V.R. is as follows:
HANDLE: Under 2DH <-- 7D~83H --> Over D3H
left
(
Centerin
g
p
osition
)
ri
g
ht
ACCEL: Under 30H ---> Over COH
BRAKE: Under 30H ---> Over D2H
(
the
p
edal released
)
(
the
p
edal ste
pp
ed
)
Pa
g
e 1 of 1In
p
ut Test
7/12/2005htt
p
://www.sauservice.com/manuals/Da
y
tona%20Folder/DDhtml/DD26.html