Filter
Top Products
44 C1519M-E (6/06)
MULTIPLEXER CONTROL
You can also control multiplexers with the KBD960 keyboard. You can connect multiplexers to any input.
Refer to the CM6800 Installation/Operation Manual for instructions on setting the multiplexers for keyboard control.
Follow these steps to control multiplexers:
1. Enter a MUX input number and press . Each MUX input is associated with a camera input. Figure 43 shows MUX 1 being controlled.
2. Select . MUX Menu 1 appears. should be highlighted, which means you have MUX control.
3. Cycle through the 16 picture inserts (if you have a 16-channel multiplexer) by entering the camera number and selecting .
4. Select again to zoom into the MUX camera. You can move the joystick to view a specific area.
5. Select to bring up MUX Menu 2. The icons for a picture-in-picture display, 4-camera display, 9-camera display, and 16-camera
display appear.
6. Select to view four of the available 16 cameras on one monitor. You can cycle through all 16 cameras, four at a time, by repeatedly
selecting .
7. Select to view nine of the available 16 cameras on one monitor. Select again to see the remaining seven cameras.
8. Select to view all 16 available cameras on one monitor.
NOTE: does not work on a 9-channel multiplexer.
Figure 43. MUX Control Menu
MUX MUX
LOG
O
FF
PRSTGPIMUX
1 1
00934