Filter
Top Products
C1519M-E (6/06) 29
SENDING/RECEIVING KEYBOARD SETUPS
You can set up only one KBD960 keyboard and send the information to another keyboard. You can also receive the setup information from a
connected keyboard.
The COM ports are located on the bottom of the keyboard.
Follow these steps to send or receive setup information between keyboards:
1. Select from Define Menu 2 to bring up the Database Menu. See Figure 31.
2. Select to send setup information to a connected keyboard.
“Sending Data” appears on the LCD. “Key Data Sent” appears on the LCD when the transfer is complete.
or
Select to receive setup information from a connected keyboard.
“Receiving KeyDefs” appears on the LCD. “Keys Uploaded” appears on the LCD when the transfer is complete.
NOTES:
• COM 3 is RS-232 and is only used for sending/receiving settings between keyboards. It is not used for normal operation.
• To send/receive setup information, all KBD960 keyboards must be connected to the M bus. However, each keyboard must have a unique
local M device address.
Table U. Database Menu
Select to send the keyboard’s key configuration to another keyboard. You must enter the local
device address of the second keyboard. This is only sent to a device on the same bus as the
keyboard.
Select to receive another keyboard’s key configuration database. You must enter the local device
address of the second keyboard. This is only sent to a device on the same bus as the keyboard.
Select to return to the Define Menu.