Filter
Top Products
36 C1519M-E (6/06)
PATTERN LENGTH
You can set three time values for single pattern lengths and three corresponding time values for two half-pattern lengths from the Esprit
™
Programming Menu. The single pattern lengths are 1.5 minutes, 3 minutes, and 6 minutes. The corresponding half-pattern lengths are
0.75 minutes, 1.5 minutes, and 3 minutes.
Follow these steps to bring up the programming menu:
1. Go to Define Menu 2. Refer to Table C.
2. Enter 95 and press the Prst side of .
The monitor displays the Preset Label Menu. The Programming Menu appears when you click Set.
3. Perform the steps in Table V.
NOTE: If the Esprit programming menu shows no choices for pattern creation, then you have early models and are limited to creating and
running patterns based on the time values of 60 seconds for full and 30 for half-patterns. Intercept
®
equipment also uses 60 seconds for a full
pattern and 30 seconds for half-patterns.
STARTING PATTERNS
1. Select from Main Menu 1.
2. Select . “RUNNING PATTERN” appears on the monitor. The pattern runs from start to finish, returns to its start position, and
begins again.
STOPPING PATTERNS
Move the joystick to stop a running pattern.
Table V. Esprit Programming Menu
1. Move the joystick to position the cursor beside Other.
2. Press the Open side of to enter the submenu.
3. Position the cursor beside Pattern Length.
4. Press the Open side of .
5. Scroll through the available pattern lengths (1.5, 3, or 6). For two half-patterns of 0.75 minutes each, select 1.5;
for two half-patterns of 1.5 minutes each, select 3; and for two half-patterns of 3 minutes each, select 6.
6. Press the Open side of to make your time selection.
7. Exit the menu.
PRST