Filter
Top Products
7
Introduction
Overview
This unit is a controller which is designed to control remote cameras.
It can be used to control up to 100 remote cameras when IP connections
are used, and up to 5 remote cameras when serial connections are
used.
Also, operation linked to an AW-HS50 compact live switcher can be
implemented by means of an IP connection.
Required personal computer environment
Run the software that is supplied with the unit on a personal computer
which satisfies the following specifications.
CPU Intel
®
Core
TM
2 Duo 2.4 GHz or faster, or a CPU with
equivalent specs.
Memory Windows XP: 512 MB or more
Windows 7: 1 GB or more
Network function 10BASE-T or 100BASE-TX
Image display
function
Resolution: 1024768 pixels or more
Color generation: True Color (24 bits or more)
Supported
operating systems
Windows XP
Windows 7
Hard disk drive At least 50 MB of free space
Other CD-ROM drive
(For using the Operating Instructions and various
software)
Adobe
®
Reader
®
(For browsing the Operating Instructions on the
CD-ROM)
Disclaimer of warranty
IN NO EVENT SHALL Panasonic Corporation BE LIABLE TO ANY
PARTY OR ANY PERSON, EXCEPT FOR REPLACEMENT OR
REASONABLE MAINTENANCE OF THE PRODUCT, FOR THE
CASES, INCLUDING BUT NOT LIMITED TO BELOW:
(1) ANY DAMAGE AND LOSS, INCLUDING WITHOUT LIMITATION,
DIRECT OR INDIRECT, SPECIAL, CONSEQUENTIAL OR
EXEMPLARY, ARISING OUT OF OR RELATING TO THE
PRODUCT;
(2) PERSONAL INJURY OR ANY DAMAGE CAUSED BY
INAPPROPRIATE USE OR NEGLIGENT OPERATION OF THE
USER;
(3) UNAUTHORIZED DISASSEMBLE, REPAIR OR MODIFICATION
OF THE PRODUCT BY THE USER;
(4) INCONVENIENCE OR ANY LOSS ARISING WHEN IMAGES
ARE NOT DISPLAYED, DUE TO ANY REASON OR CAUSE
INCLUDING ANY FAILURE OR PROBLEM OF THE PRODUCT;
(5) ANY PROBLEM, CONSEQUENTIAL INCONVENIENCE,
OR LOSS OR DAMAGE, ARISING OUT OF THE SYSTEM
COMBINED BY THE DEVICES OF THIRD PARTY;
(6) ANY INCONVENIENCE, DAMAGES OR LOSSES RESULTING
FROM ACCIDENTS CAUSED BY AN INADEQUATE
INSTALLATION METHOD OR ANY FACTORS OTHER THAN A
DEFECT IN THE PRODUCT ITSELF;
(7) LOSS OF REGISTERED DATA CAUSED BY ANY FAILURE;
(8) ANY DAMAGE OR CLAIMS DUE TO LOSS OR LEAKAGE OF
IMAGE DATA OR SETTING DATA SAVED ON THIS UNIT OR ON
A MEMORY CARD OR COMPUTER.
Network security
As you will use this unit connected to a network, your attention is called
to the following security risks.
(1) Leakage or disclosure of information transmitted via this unit
(2) Unauthorized use of this unit by a third person with malicious
intent
(3) Interference or stoppage of this unit by a third person with
malicious intent
It is your responsibility to take sufficient network security measures such
as those described below to protect yourself against the above risks.
Use this unit in a network secured by a firewall, etc.
If this unit is used in a system with a computer connected, make
sure that checks for and removal of computer viruses and malicious
programs are implemented regularly.
Do not install the unit in a location where the unit, cables, and other
parts may be easily damaged.
User authentication
The user authentication function of this unit uses basic authentication.
When basic authentication is used on an unsecured network, there is
the risk of passwords being leaked.
We recommend using host authentication in such a case.
Configure the host authentication settings on the remote cameras. For
details, refer to the operating instructions for the remote cameras.
Restrictions on use
With regards to the network for connecting the remote cameras and
personal computer to the unit, we recommend that the segment is the
same.
If there are connections for which the segment is different, events
dependent upon, for example, settings unique to the network equipment
may occur so carefully check the connections prior to the start of
operation.