Filter
Top Products
10
Precautions for installation
In addition to the safety precautions given in “Read this first!”, also observe the following instructions.
Be sure to ask your dealer to perform the installation and connection work for the unit.
Connecting a power supply
Insert the DC plug for the external DC power supply all the way in
until it locks into place.
REMOTE
LCD CONTRAST
POWER
ON
SIGNAL GND
12V IN
DC plug
When the unit will not be used for a long time, turn off the power
switch and remove the DC plug for the external DC power supply to
save power.
Do not allow any foreign objects to enter inside the unit
Allowing water, metal items, food or drink, or other foreign objects to
enter inside the unit may cause a fire or electric shock.
Installation location
This unit is designed for indoor use only.
Install and use the unit in a stable location.
Avoid installing the unit where it will be exposed to direct sunlight.
Installing the unit in a location with a lot of humidity, dust, or vibration
may result in a failure.
Example of embedding the unit in a desktop
When you will use the unit embedded in a desktop, refer to the following procedure.
1. Make mount angles suitable for the installation location.
<Mount angle example>
Desk mounting side (unit: mm (inch))
Unit mounting side
160 (0000)
Ø5 (0000)
(Desk mounting holes)
25 (0000)
210 (0000)
140 (0000)
Ø3.5 (0000)
(Unit mounting hole)
21
(0000)
35
(0000)
30
(0000)
1.2 (0000)
2. Attach the mount angles to the sides of the unit with
four M3 screws.
Unit
M3 screws
Mount angle
For details on the dimensions for attaching mount angles to the
unit, refer to “Appearance” (page 11).
Note
3. Insert the unit into the desktop hole and then fix it in
place with four screws
Provide screws that match the size of the desktop mounting holes
(e.g. Ø5 mm (00 inches)).
4. If necessary, make and attach a panel to cover the rest
of desktop hole.
Panel to cover hole