Filter
Top Products
31
192.168.000.010
192.168.000.011
192.168.000.010
192.168.000.010
192.168.000.010
192.168.000.012
192.168.000.008
192.168.000.008
192.168.000.009
Remote
camera A
Remote
camera B
Remote
camera C
Switcher
Unit
CAM1
CAM3
CAM2
The subnet mask, default gateway, and port number settings are
set the same as those for the unit.
For the camera numbers for which auto IP setting is executed, the
connection type becomes “Network” and the camera numbers are
excluded from the setting targets the next time auto IP setting is
executed.
However, camera numbers for which the connection destination IP
address was changed manually or connection type was changed
to “NoAsign” or “Serial” and then returned to “Network” after auto
IP setting was executed become target for auto IP setting again.
<Operating procedure>
Before configuring the settings, check that the connection types
of the remote cameras are “NoAsign”.
Connection type settings
CTRL TYPE menu [36] → “1. CAM1” to “100. CAM100” items
Note
1. Connect the remote cameras, switcher and unit to the
network within the same subnet.
2. Open AUTO IP menu [37], turn the F2 dial to display
“RENEW IP ADR” and press the F2 dial.
1.AUTO SET
RENEW IP ADR
Both the number of devices (all remote cameras and the switcher)
currently being managed by the unit and the number of new devices
detected are displayed on the LCD panel.
C:003/003 S:1/1
NO
C:003/003
Number of devices currently managed by the unit
+ number of new devices detected
Number of new devices detected
C: Remote camera, S: Switcher
3. Turn the F2 dial to select “Yes”, and then press the F2
dial.
Auto IP setting starts.
During auto IP setting, the progress is indicated by the number of
“
” which are reduced one by one.
1.AUTO SET
When all the operations have been completed successfully, the
following message appears.
1.AUTO SET
COMPLETE
The remote cameras and the switcher are automatically rebooted,
and they restart with the new IP addresses that were set.
The remote cameras can now be operated from the unit.
The function for linking the switcher with the unit can now be used.
When setting the IP addresses failed, the following message
appears.
1.AUTO SET
SET UP ERR!
The cause of the problem is likely to be a network malfunction.
Check the connection status of the hub and LAN cables, and then
retry the auto IP setting operation.
Settings for connecting with the remote cameras and switcher (continued)