Filter
Top Products
36
Setting the connection destination port
number
Set this when the remote camera needs to be identified by a port
number such as when connecting via a router.
The connection destination port number of the switcher cannot be set.
1. Open PORT NO menu [40] and turn the F1 dial to display
the camera number for which you want to change the
setting.
1.CAM1
80
2. Turn the F2 dial to select a value, and then press the F2
dial to confirm the selection.
This is set to “80” by default for all of the camera numbers CAM1
to CAM100.
When you enter a value that cannot be set, the following message
appears and the port number is not set.
Unavailable
network setting
Settable port numbers
You can set a value within the range of 1 to 65535.
However, the following values cannot be set even though they are
within this range.
20, 21, 23, 25, 42, 53, 67, 68, 69, 110, 123, 161, 162, 995,
10669, 10670
Manually setting the connection destination
IP address (switcher)
Use the following procedure to manually set the link settings for the unit
and switcher.
1. Open SW SETUP menu [41] and turn the F1 dial to
display the “2. SW IP ADDRESS” item.
2.SW IP ADDRESS
192.168.000.008
This is set to “192.168.000.008” by default.
2. Use the F2 dial to set the IP address for the connection
destination.
Enter this in four blocks of numerals.
Enter all of the blocks and then press the F2 dial to confirm the IP
address.
Initializing the connection destination IP
addresses set on the unit
Use the following procedure to initialize the connection types and
connection destination IP addresses set on the unit.
1. Open AUTO IP menu [37] and turn the F2 dial to display
“ALL CLEAR”.
1.AUTO SET
ALL CLEAR
2. Press the F2 dial to execute initialization.
The settings for connecting with the remote cameras and switcher
are initialized.
When the connection type is set to “Network”, it is changed to
“NoAsign”.
When the connection type is set to “Serial”, it is not changed.
If the IP address of the unit in RP SETUP menu [25] is
changed, the connection destination IP addresses are changed
automatically.
• IP addresses after the IP address of the unit are set for the
camera numbers in ascending order.
• The value immediately before the IP address of the unit is set as
the connection destination IP address of the switcher.
Settings for connecting with the remote cameras and switcher (continued)