Filter
Top Products
4 Installation
4.3 Direct mounting
25
FX3U-CF-ADP User's Manual
1
Introduction
2
Specification
3
System
Configuration
4
Installation
5
Wiring
6
Functions
7
Before
Programming
8
CF-ADP Applied
Instructions
Explanation
9
Program
Examples
10
Troubleshooting
4.3 Direct mounting
When the CF-ADP is connected to a FX3U PLC, the CF-ADP may be mounted directly on a panel surface
using screws. The direct mounting method is not available when the CF-ADP is connected to a FX
3UC PLC.
Connect the CF-ADP to the main unit before attaching it to the panel surface.
For mounting, refer to the following manual.
→ Refer to the FX
3U Hardware Edition
1 Create mounting holes in the
mounting surface according to the
external dimensions diagram.
2 Fit the CF-ADP to the mounting
holes and tighten with M4 screws
(A in the figure on the right).
Also fit the main unit to the mounting holes
and tighten with M4 screws. For the main unit
connection method, refer to the following.
→ Refer to the FX3U Hardware Edition
It is assumed that the CF-ADP has been
connected in advance.
For the CF-ADP connection method, refer to
the following.
→ Refer to Section 4.1.
For the screw positions and number of screws in the CF-ADP, refer to the dimensional outline
drawing as follows.
→ Refer to Section 1.2.
For the screw positions and number of screws in the main unit, refer to the following manual.
→ Refer to the FX3U Hardware Edition
A
A