Filter
Top Products
4 Installation
4.1 CF-ADP Connection
23
FX3U-CF-ADP User's Manual
1
Introduction
2
Specification
3
System
Configuration
4
Installation
5
Wiring
6
Functions
7
Before
Programming
8
CF-ADP Applied
Instructions
Explanation
9
Program
Examples
10
Troubleshooting
4.1 CF-ADP Connection
An expansion board should be installed before connection of the CF-ADP. An expansion board is not required
when the CF-ADP is connected to a FX
3UC(D, DSS) PLC.
This section explains an example where the CF-ADP is connected to a FX
3U PLC. For connection to another
PLC, refer to the respective PLC manual.
→ Refer to the FX
3U Hardware Edition
→ Refer to the FX
3UC Hardware Edition
1 Remove the special adapter connector cover
(A in the figure on the right) from the expansion
board.
It is assumed that an expansion board has been installed in
advance. For the expansion board installation method, refer
to the respective PLC manual.
→ Refer to the FX3U Hardware Edition
→ Refer to the FX
3UC Hardware Edition
2 Slide the special adapter connecting hooks
(B in the figure on the right) of the main unit
upwards.
3 Connect the CF-ADP (C in the
figure on the right) to the main
unit as shown in the figure on the
right.
4 Slide the special adapter
connecting hooks (B in the figure
on the right) of the main unit
downwards to secure the CF-ADP
(C in the figure on the right).
2
2
B
A
B
1
4
4
B
B
3
3
3
C