Filter
Top Products
3 System Configuration
3.2 Applicable PLC
19
FX3U-CF-ADP User's Manual
1
Introduction
2
Specification
3
System
Configuration
4
Installation
5
Wiring
6
Functions
7
Before
Programming
8
CF-ADP Applied
Instructions
Explanation
9
Program
Examples
10
Troubleshooting
3.2 Applicable PLC
3.2.1 Connectable PLC
The version number can be checked by reading the last three digits of device D8001.
*1. An expansion board is required to connect the CF-ADP with FX
3U/FX3UC-32MT-LT PLCs.
*2. The FX
3UC-32MT-LT-2 PLC is due to be upgraded later.
3.2.2 Applicable versions of the programming tool
1. GX Developer
Use the programming tool with the following version number to create programs for the CF-ADP of the FX3U/
FX
3UC Series PLC.
Caution
If a programming tool with the wrong version number is used, programming will not be possible.
3.3 Connection with PLC
The CF-ADP connects with a FX3U/FX3UC PLC via an interface connector.
Only one CF-ADP unit can be connected to the FX
3U/FX3UC PLC. An expansion board is required to connect
the CF-ADP with the FX
3U/FX3UC-32MT-LT PLCs.
For details of assignment of channel numbers in the main unit, refer to the following.
→ Refer to Section 3.4
1. FX3U/FX3UC-32MT-LT PLC
Model name Applicability
FX3U Series PLC
*1
Ver. 2.61 and later
Only one CF-ADP unit can be connected to a main unit.
FX3UC Series PLC
*1*2
Ver. 2.61 and later
Only one CF-ADP unit can be connected to a main unit.
Software Applicability
GX Developer
• SW D5C(F)-GPPW-J
• SW D5C(F)-GPPW-E
Ver.8.82L or later
Other
special adapters
Expansion board
Main unit
FX
3U
-CF-ADP