Filter
Top Products
38 Driver Installation
The package is a gzipped tar file. After downloading the package to a Linux
system, perform the following steps:
1
Unzip the package using
gunzip
.
2
Untar the file using
tar -xvf
.
The DUD image can be transferred to a USB flash key, system floppy disk
slot, or USB floppy device depending upon the availability of the media type
and the operating system.
•
USB key method
: Transfer the appropriate
.img
file to a USB key
•
System floppy Fisk slot method
: Use the
dd
command to create a DUD.
Use the appropriate image for the purpose.
a
Insert a floppy disk into the system floppy disk slot.
b
At a terminal prompt, type the following:
# dd if=
<image_file_name> of=/dev/fd0
•
USB floppy device method
: Use the
dd
command to create a driver
update disk. Use the appropriate image for the purpose.
a
Put a floppy disk into a USB floppy device and plug the device into a
USB slot of the system under test. Use
dmesg
to find out to which
device this USB floppy is enumerated (for example,
sdb
,
sdc
, etc).
b
Transfer the driver image to the floppy:
# dd if=
<image_file_name> of=/dev/sdx
NOTE: You can create a driver update disk on a Windows system using the
program dcopynt.
3
Use the diskette for operating system installation. For Red Hat Enterprise
Linux, see "Installing Red Hat Enterprise Linux Operating System Using
the DUD" on page 39. For SUSE Linux Enterprise Server, see "Installing
SUSE Linux Enterprise Server Using the DUD" on page 40.
PERC H200.book Page 38 Tuesday, July 13, 2010 4:15 PM