Filter
Top Products
34 Driver Installation
3
Press the <S> key.
The system prompts for the driver media to be inserted.
NOTE: The driver can be provided using a properly formatted USB key.
Check the Dell Support website at
support.dell.com for additional details.
4
Insert the driver media in the media drive and press <Enter>.
A list of SAS controllers appears.
5
Select the right driver for the installed controller and press <Enter> to
load the driver.
NOTE: For Windows Server 2003, a message can appear that states that the
driver that you provided is older or newer than the existing Windows driver.
Press <S> to use the driver that is on the media.
6
Press <Enter> again to continue the installation process as usual.
Installing the Driver During a Windows Server 2008 or Windows Server
2008 R2 Installation
Perform the following steps to install the driver during operating system
installation.
1
Boot the system using the Windows Server 2008 or the Windows Server
2008 R2 media.
2
Follow on-screen instructions until you reach the message
Where do you
want to install 7/2008
; then select
Load driver...
3
The system prompts for the media to be inserted. Insert the installation
media and browse to the proper location when prompted.
4
Select the appropriate PERC H200 card from the list, click
Next
and
continue installation as usual.
NOTE: The Windows Server 2008 R2 operating system includes native support for
the PERC H200 card. The driver is automatically installed. For driver updates, see
the Dell Support website at support.dell.com.
PERC H200.book Page 34 Tuesday, July 13, 2010 4:15 PM