Filter
Top Products
Clarity User Guide, March 1, 2011 - Rev. 1.06
Page 6
9. Main fuse (located on rear bulkhead)
10. Glass plate (See Fig. 1.5) Remove and install in the blocking chamber as described
later in this chapter.
11. Light shield (blocking arm)
12. Light shield (left gripper)
13. Light shield (right gripper)
14. Bag of screws for the light shielding
15. Clarity User Guide (not shown in Fig. 1.4)
When the Clarity is prepared for shipment (by the factory or the user), its mechanism must be
secured against movement caused by jarring or shocks to the shipping carton. Units may use
one of two means for doing this: (1) molded foam blocks within the blocking chamber, or (2)
a clamping device attached to the blocking mechanism. In either case, the shipping restraints
must be removed prior to using the Clarity, and must be re-installed prior to shipping the unit,
should that prove necessary.
CAUTION
Shipping the unit without properly re-installing the factory shipping
restraints may cause severe damage to the equipment.
Foam Shipping Blocks in the Blocking Chamber
Remove the two foam blocks that hold the mechanism in place during shipment. Note how
they are installed in the event that the Clarity needs to be shipped from your location. Call
Technical Support for help in packing the machine for shipment. Figures 1.1a and 1.1b show
how the foam shipping blocks are installed.
Figure 1.1a - Block #1 (P/N 33593 - Bottom Shipping Block)