Atari 3 Video Games User Manual


 
raised water body; and ii) the width of the lower water body underneath this edge into which
the waterfall will discharge. Use this information to create waterfalls of whatever height and
width you choose.
Using the RollerSoaker
One of the rides in RollerCoaster Tycoon 3: Soaked! is the RollerSoaker, which fea-
tures controls for riders to release several gallons of water, soaking the guests
walking below.While riding the RollerSoaker, find the button labeled “release
water” located in the coaster cam interface, and click the button to dump gallons
of the wet stuff.To get an optimal view of the RollerSoaker releasing water, position the
Coaster Cam to look backwards and then zoom out.
Creating Dolphin and killer whale Shows
Before you add a dolphin or killer whale show, you must first create a water body
using the terrain tools, and one that is deep enough to accept the show “object.”
See the RollerCoaster Tycoon 3 manual for instruction on creating bodies of water.
After you’ve finished building the water body, select either dolphin or killer whale show from
the Gentle Rides, position the ride in the water, and then click to add the attraction. If the
water is too shallow, the color of the attraction will remain red.The fastest way to adjust the
water body to the proper depth is to hold down the Alt key while the show is positioned over
the water – when the color of the attraction turns blue, click to add it there.
Finally, add an entrance and exit, connect them to your park’s path system and open the show
just like other attractions.
After you’ve placed the show, you can customize the
contents of the show by clicking the Aquatics MixMaster
button found in the attraction’s control panel.
When clicked, the RCT3 MixMaster
sequencer interface
will be displayed where you can add any of the choreo-

To add a tall diving board, select the highdiving board from the Pool Extras, move
the pointer to the area where the diving board will be constructed, and then hold
the mouse button as you nudge the mouse upward.
To add a wave machine, choose the wave-machine item, move the pointer to the
edge of the pool and then click to add it to the pool edge.
To add a water slide that empties into your pool, build the water slide so
the slide’s end-piece connects to the edge of the pool decking, and then
make sure pool parts have been built around the water slide’s end-piece
to provide a splash zone.
To adjust the price of a pool area, and to perform other tasks like mainte-
nance, click the changing room for that pool and make adjustment in the control panel that
appears there.
Creating Waterfalls
Waterfalls can only be constructed between two adjacent bodies of water where one is higher
than the other.
First, modify the terrain to create a raised area — for best results, use the
tool to create a mesa. Next, create a pit on the mesa and then add water
(consult the RollerCoaster Tycoon 3 manual for instructions on adding
water bodies).This higher water body must have a flat, straight edge over
which the water can flow.Then, create a pit at the base of the raised area
and add water there, too, ensuring that there is at least some water in
the lower body that is roughly underneath the edge over which you want the water the flow.
Finally, click the Waterfalls button (as seen on page 10) to activate the waterfall function, then
click the raised water body to select it, and then click the lower water body to select it. If the
terrain has been formed properly, a waterfall will be created automatically.The width of the
waterfall is selected based on the narrower of i) the length of the flat, straight edge on the
