Filter
Top Products
Using the Swimming Pool Editor.
Click the Scenery button, and then click the Swimming Pools button at the bottom of the list.
This will open the Swimming Pool Construction toolbox.
First take a look at the interface and notice you can add the following:
• Pool paths (to add footbridges and to create elevated areas)
• Pool extras (to add ladders, lights, showers, and diving boards)
• Pools (swimming areas)
• Pool changing rooms (where peeps in your park enter and exit the pool area)
• Save (to save your pool designs).This option is present when the pool changing room
window is open.
Select the Pools button and then choose a pool edge-type, and then draw the
pool over a flat area in your park to add the pool. If you want an elevated pool,
click the toggle-snap icon and then adjust the number to indicate how high the
pool will be constructed.
Next, select the Place Tiles button to construct decking around the pool.As with pool con-
struction, you can add raised decking by clicking on the
toggle-snap icon and adjusting the height value and then
drawing in the park to construct decking.
Add plenty of decking around a pool so you can add lounge
chairs, showers, diving boards and waterslides.
mix! You can also preview each effect now. In addition, you can customize the laser displays
and the water displays using the Advanced Designer, and then save these creations to be used
later or shared with the on-line RollerCoaster Tycoon community.
As with the fireworks shows, you’ll first need to add the kind of launchers to your park for the
type of effects (fireworks, water jet, laser) you want to use in your show, and then open a
show timeline to add these elements.
To add launchers, click the Scenery button, and then click RCT3
MixMaster
™
button to display the RCT3 MixMaster
™
console.
Next, click the MixMaster Bases button to see the launcher
bases for water jets and lasers as well as fireworks – click one
of these to choose it and then click the place in the park where
you want that launcher to reside.At any time, you can click on
a launcher located in your park to open the RCT3 MixMaster
™
interface.
Next, click the MixMaster Displays button to open a sequence timeline. In the same way fire-
works shows were created, click the timeline where you want to add a show event, and
choose an event from the pop-up window to add it to the timeline.