Setting and Verifying the Network Connection
If the Test Fails
When the system is connected to a heavily loaded active
network, failure may occur. If the
test ni
test fails, repeat
the test several times. If the test continues to fail, connect the
loopback connector as shown in Figure 4–2, and run the test
again. If an error message appears, see Chapter 13 for more
information.
Completing the Network Connection
Contact Your
Network
Administrator
Once you determine that your network cables are connected
securely, and your system starts up and tests without errors,
contact your network administrator to configure your workstation
as part of your network.
If your system displays any error messages during the startup
test, see Chapter 13 to determine the problem.
5–14 Connecting Your System to a Network
