A SERVICE OF

logo

Moving the Secure System Jumper
Step 3: Release
Driveplate
After removing the system unit cover, locate and loosen the four
thumbscrews that hold the driveplate in place . Remove the
SCSI drive cable from the driveplate, as shown in Figure 11–2 to
release the driveplate, by pushing out the plastic tabs on either
side of the cable connector and pulling on the white tab .
Figure 11–2 Releasing the Driveplate
A .......... TLZ06
B .......... RX26
C .......... TZK20
D .......... TZ30
E .......... RRD42
A
B
C
D
E
MLO-009206
2
1
Using the Password Security Feature 11–7