Moving the Secure System Jumper
Moving the Secure System Jumper
Secure System
Jumper
After entering a password and enabling the secure environment
variable, you must move the secure system jumper on the I/O
board to complete the security feature on your system. This
section describes the steps required to move the jumper.
Task Overview
Table 11–3 lists the steps required to move the secure system
jumper.
Table 11–3 Steps to Moving Secure System Jumper
Step Description
1 Turn off the system
2 Remove system unit cover
3 Release driveplate
4 Move driveplate
5 Move secure system jumper
6 Replace driveplate
7 Reconnect drive cable and thumbscrews
8 Replace system unit cover
9 Turn on system
Step 1: Turn
Off the System
Your system must be shut down before you continue.
If the operating system software is running or if the console
prompt (>>>) is displayed, see Chapter 7 for instructions on how
to shut down the operating system and turn off the system.
CAUTION:
Capacitor
Discharge
After you turn off the system and before you open the system
unit, wait about fifteen seconds to allow time for the supply
capacitors to safely discharge.
Using the Password Security Feature 11–5
