A SERVICE OF

logo

Open as PDF
next previous
*
SECTION CONTROLS
3. Scaling factor, , for the hourglass stiffness for use with the out-of-plane displacem ent degree
of freedom in small-strain shell elements in ABAQUS/Explicit. If this value is left blank,
ABAQUS/Explicit will use the default va lue of 1.0. The suggested range for the value of
is between 0.2 and 3.0. This scaling factor is not relevant for ABAQUS/Standard.
4. Scaling factor for the linea r bulk viscosity in ABAQUS/Explicit. If this value is left blank,
ABAQUS/Explicit will use the default value of 1.0. The suggeste d range for the value is
between 0.0 and 1.0. This scaling factor is not relevant for ABAQ US/Standard.
5. Scaling factor for the quadratic bulk viscosity in ABA QUS/Explicit. If this value is left blank,
ABAQUS/Explicit will use the default value of 1.0. The suggeste d range for the value is
between 0.0 and 1.0. This scaling factor is not relevant for ABAQ US/Standard.
18.1–5
ABAQUS Version 6.1 Module:
ID:
Printed on: