Filter
Top Products
Response: Displays port parameters.
Example: To display parameters for a port named "SERVER", access the Command Mode from
a port with Supervisor Level command capability, and type /W SERVER [Enter].
/X Exit Command Mode
Exits Command Mode, When issued at the Net Port, also ends the telnet session. Note that
exiting from Command Mode will not terminate port connections.
Any-to-Any Mode: Exits Command Mode.
●
Modem Mode: Disconnects and resets modem, hang-up message is sent, hardware line to
modem drops for 500 ms, and reset message is sent.
●
Availability: Supervisor / User
Format: /X [Enter]
Response: Disconnected
Appendix A. RS232 Port Interface
Figure A.1: RS232 Port Interface
DCD and DTR hardware lines function as follows:
When connected:
If either port is set for Modem Mode, the DTR output at either port reflects the
DCD input at the other end.
.
1.
WTI CMS-16; Console Management Switch -- User's Guide
file:///C|/WEBPAGE/guides/cms/html/rev_b/Cmsguide.htm (57 of 59) [11/15/2000 10:52:03 AM]