Filter
Top Products
Verbose: Connected xx, when a Resident Connection is initiated, the CMS will also display
the currently selected Resident Disconnect Sequence for your port.
Terse: 1
/CP Copy RS232 Port Parameters
Allows quick set-up when all CMS RS232 ports will be configured with the same or similar
parameters. When the /CP command is invoked, the CMS will display a menu that is used to
select common port parameters, which can then be copied to all CMS RS232 ports. For more
information, please refer to Section 5.6.
Availability: Supervisor Only
Format: /CP [Enter]
Response: Displays Copy Parameters Menu
/D Third Party Disconnect
Invoke the /D command at your resident port to disconnect two other ports. The /D command
cannot be used to disconnect your resident port. To disconnect your resident port, issue the
Resident Disconnect Sequence or wait for the Timeout Period to elapse (if enabled).
Availability: Supervisor Only
Format: /D[/Y] <x> [x] [Enter]
Where:
/Y
(Optional) suppresses the "Sure?" prompt.
x
Is the number or name of the port(s) to be disconnected. To Disconnect all ports, enter an
asterisk. To disconnect the Network Port, enter an "N".
Response:
Verbose: "Are you Sure (y/n)?", if Y, unit will respond with "Disconnected".
Terse: 5, if Y, unit will respond with 3.
Example: To disconnect Port 2 from Port 3 without the "Sure?" prompt, access the Command
Mode from a third port with "All" command capability and type one of the following commands:
/D/Y 2 [Enter] or /D/Y 3 [Enter]
/E Erase Buffer
Erases data from the buffer for a specified port or several ports. Note that erased data cannot be
WTI CMS-16; Console Management Switch -- User's Guide
file:///C|/WEBPAGE/guides/cms/html/rev_b/Cmsguide.htm (52 of 59) [11/15/2000 10:52:03 AM]