Filter
Top Products
Erase Buffer
/E[/Y] <x> [x] [Enter]
/E[/Y] * [Enter]
X
Reset Network Port
/T [Enter]
X
Default & Test
/I[/Y] [Enter]
X
Save Parameters
/U [Enter]
X
Upgrade Firmware
/UF [Enter]
X
(1)
Supervisor Mode displays parameters for all ports;
User Mode only displays parameters for the ports allowed by the Port
Password.
(2)
To display Port Passwords, include the "P" Option. (Supervisor Only).
(3)
A port with "User" command capability can only view its own
parameters. A User Port cannot view parameters for other ports.
(4)
A User Port cannot perform a Third Party Connect.
(5)
Resident Disconnect: Disconnects your resident port from another
port. Note that the Resident Disconnect Sequence can be redefined via
the Port Configuration Menus.
(6)
Third Party Disconnect: Disconnects two or more nonresident ports.
Must be issued from a third port with Supervisor command capability.
10.4. Command Set
This Section provides more detailed information on all CMS commands, sorted alphabetically by
name.
[Enter] Enter Command Mode
In order to set parameters or connect ports, you must first access the command mode as
described in Section 5.1. When the Command Mode is inactive (port asleep), the port will only
respond when the [Enter] key is pressed without any characters preceding it. If the Supervisor
Password (command /F) has been defined, the unit will require a password before allowing
access to Command Mode.
Availability: Supervisor / User
Format: [Enter] (Press [Enter] twice if other characters have already been typed).
Response: The Port Status Screen will be displayed, followed by the "CMS>" command
prompt.
WTI CMS-16; Console Management Switch -- User's Guide
file:///C|/WEBPAGE/guides/cms/html/rev_b/Cmsguide.htm (50 of 59) [11/15/2000 10:52:03 AM]