Filter
Top Products
73. Hang-Up String: Defines the modem hang-up message. Although the CMS
will pulse the DTR line in order to hang-up an attached modem, the Hang-Up string
is often useful for controlling modems that do not use the DTR line. (Default =
undefined).
❍
8. Supervisor Mode: Permits or denies port access to Supervisor Mode. When this item
is enabled (Permit), and the valid Supervisor Password is entered, the port will be allowed
to invoke Supervisor Level commands. If this item is disabled (Deny), the port may not
enter Supervisor Mode, even when the Supervisor Password is entered. (Default =
Permit).
●
9. Logoff Character: Defines the Logoff Character for this port. The Logoff Character
determines the command sequence that must be issued at this port in order to disconnect
from a second port (Resident Disconnect). Note the following:
The default Logoff Character is "+". As a result, the default Resident Disconnect
Sequence is [Enter]+++[Enter].
❍
The default three character Resident Disconnect Sequence uses the format
"[Enter]LLL[Enter]", where L is the Logoff Character. If the one character
disconnect is selected (see item 10), a resident connection is terminated by simply
typing the Logoff Character once (without carriage returns).
❍
●
10. Sequence Disconnect: Enables/Disables and configures the Resident Disconnect
command. This prompt offers the option to either disable the Sequence Disconnect, select
a three character format, or select a one character format. (Default = Three Characters).
Note the following:
When a Resident Connection is initiated, the CMS will send a message which lists
the connected ports, and displays the one character or three character disconnect
command that will be required in order to terminate the connection.
❍
The One Character Disconnect sequence is intended for situations where the
destination port should not receive the disconnect command. When the Three
Character format is selected, the disconnect sequence will pass through to the
destination port prior to breaking the connection.
❍
When the Three Character format is selected, the Resident Disconnect Sequence
will use the format "[Enter]LLL[Enter]", where L is the selected Logoff Character.
❍
When the One Character format is selected, resident connections are terminated by
entering the selected Logoff Character only. There is no need to press [Enter]
before and after the Logoff Character when the One Character format is selected.
❍
●
WTI CMS-16; Console Management Switch -- User's Guide
file:///C|/WEBPAGE/guides/cms/html/rev_b/Cmsguide.htm (26 of 59) [11/15/2000 10:52:02 AM]