Filter
Top Products
Up Down Up 38.4K
Down Up Up 57.6K
Up Up Up 115.2K
* = Factory Setting
4.2.2. Default Handshake (Sw4, Sw5)
The default handshake format must match the format your control device will use when
communicating with the CMS. Option Switches 4 and 5 can select RTS/CTS (hardware),
XON/XOFF, Both or None.
Switch
Default Handshake
4 5
Down Down RTS/CTS *
Up Down XON/XOFF
Down Up Both
Up Up None
* = Factory Setting
4.2.3. Default Response Message Format (Sw6)
When commands are invoked, the CMS can respond with either verbose (English text) or terse
(numeric / abbreviated) messages. Response messages are summarized in Section 10.2. After
installation, the /P command can also set the response format to "none" (Quiet Mode). When
Quiet Mode is selected, the unit will not send response messages.
Switch 6 Default Response Message Type
Down Verbose (English Text) *
Up Terse (abbreviated / numeric)
* = Factory Setting
4.2.4. Default Command Echo (Sw7)
Switch Seven enables or disables the Command Echo. When enabled, characters sent to the
CMS will be echoed back to the control device.
Switch 7 Default Command Echo
Down Enable*
Up Disable
WTI CMS-16; Console Management Switch -- User's Guide
file:///C|/WEBPAGE/guides/cms/html/rev_b/Cmsguide.htm (15 of 59) [11/15/2000 10:52:02 AM]