Filter
Top Products
11. Timeout Disconnect: Enables and selects the Timeout Period for this port. If
enabled, and the port does not receive or transmit data for the specified Timeout Period,
the port will disconnect. When the port is set for Any-to-Any Mode, Passive Mode, or
Buffer Mode, the default setting for this item is "OFF". When the port is set for Modem
Mode, the default setting for this item is 15 minutes.
●
12. Response Type: Selects the type of messages that this port will send in response to
commands. The user can select Verbose (English Text), Terse (Numeric / Abbreviation),
or Quiet Mode (No Response). (Default = Verbose).
●
13. Command Echo: Enables or Disables the command echo for this port. (Default =
On).
●
14. Accept Break: Determines whether the port will accept breaks received from the
attached device, and pass them along to a connected port. When enabled, breaks received
at this port will be passed to any port that this port is connected to, and sent along to the
device connected to the other port. When disabled, breaks will be refused at this port, and
hence, not sent to the other port. (Default = Yes)
●
5.5.4. Network Port Configuration Menu
In order to communicate with the CMS via network, the IP Address, Subnet Mask, and Gateway
Address must first be defined using the Network Parameters Menu. If desired, the Network
Parameters menu also allows you to implement IP Security features, which can restrict command
mode access based on the user's IP Address.
Settings for network parameters depend on the configuration of your individual network. Please
contact your network administrator for appropriate settings, and then assign parameters as
described in this section.
NETWORK PARAMETERS
1. IP Address: (undefined)
2. Subnet Mask: (undefined)
3. Gateway Address: (undefined)
4. IP Security: Off
TELNET PORT PARAMETERS
11. Port Name: (undefined)
12. Supervisor Mode: Permit
13. Logoff Character: +
14. Sequence Disconnect: Three Characters
15. Timeout Disconnect: 5 Min
16. Response Type: Verbose
17. Command Echo: On
18. Accept Break: Yes
Enter: #<CR> to Change,
<ESC> Exit ...
WTI CMS-16; Console Management Switch -- User's Guide
file:///C|/WEBPAGE/guides/cms/html/rev_b/Cmsguide.htm (27 of 59) [11/15/2000 10:52:03 AM]