Filter
Top Products
NEAX2400 IPX Wireless Features and Specifications
Page 40
NDA-24313, Issue 1
P-64 PS Service Class
P-64 PS Service Class
P-65 PS Restriction Class
General Description
This service permits all the D
term
PS series to be assigned a class of service in accordance with the degree of the
system use desired.
Operating Procedure
No manual operation is required.
Service Conditions
1. The route service class is assigned to determine the accessibility to the following service features.
ANNOUNCEMENT - DON'T ANSWER
ANNOUNCEMENT - PS OUT OF CELL
CALL FORWARDING - DON'T ANSWER
CALL FORWARDING - PS OUT OF CELL
CENTREX COMPATIBILITY
2. Each D
term
PS is assigned a service feature class to determine which of the following service features the
D
term
PS will be permitted to activate.
CALL TRANSFER
CALL WAITING - TERMINATING
CENTREX COMPATIBILITY
ANNOUNCEMENT SERVICE
ANNOUNCEMENT - DON'T ANSWER/CALL FORWARDING - DON'T ANSWER
ANNOUNCEMENT - PS OUT OF CELL/CALL FORWARDING - PS OUT OF CELL
TRUNK LINE APPEARANCE
a.) ANNOUNCEMENT SERVICE /ANNOUNCEMENT - DON'T ANSWER/CALL
FORWARDING - DON'T ANSWER/ANNOUNCEMENT - PS OUT OF CELL/
ANNOUNCEMENT - DON'T ANSWER - When the restricted D
term
PS user dials the service
access code, the user receives Reorder Tone. If the CALL FORWARDING - INTERCEPT/
ANNOUNCEMENT service is set, the announcement notifying the user that an invalid number
was reached will be sent.
b.) CALL TRANSFER - When a restricted D
term
PS attempts Call Transfer (pressing of the TRF/
FLASH key), the operation will be ignored.
c.) CALL WAITING - TERMINATING - When Call Waiting is attempted to the restricted D
term
PS
which is busy, the calling party receives Reorder Tone.
d.) CENTREX COMPATIBILITY - The switch hook flash operation will be invalid.
e.) TRUNK LINE APPEARANCE - When the restricted D
term
PS user attempts to originate a call
via the TRUNK LINE APPEARANCE service, the user receives Reorder Tone.
3. Each D
term
PS is assigned a service restriction class linking to that of the PBX to restrict the user from
placing CO outgoing calls, etc. There are 15 classes and these classes are assigned in the system
parameters (traveling class mark). Refer to DIRECT OUTWARD DIALING RESTRICTION (3-9) for
more details.